Intermatic T101R3 Bedienerhandbuch PDF herunterladen

MODEL: T101R3

24 HR. DIAL TIME SWITCH (SPST)

IN TYPE 3R DUSTPROOF RAINPROOF ENCLOSURE, SUITABLE FOR POOL

EQUIPMENT CONTROL IF INSTALLED 5 FT. OR MORE FROM EDGE OF POOL.

40 AMP. RESISTIVE, INDUCTIVE TUNGSTEN OR

1000V.A. PILOT DUTY 120/208/240VOLT AC;

2 H.P. (24 FLA) - 120 V. AC; 5 H.P. (28 FLA) - 240V. AC

CLOCK MOTOR: 110-125V. 60 HZ.

WIRING INSTRUCTIONS: To wire switch follow diagram above. Use solid or strand

COPPER only wire with insulation to suit installation. See gauge selection table for

normal service applications. To make power connections remove 1/2 inch of insula-

tion from wire ends. Insert bare ends of wire under the pressure plate of terminals.

Use 3/16 or larger screwdriver to tighten terminal screws firmly. (25 lb-in minimum).

REPLACE INSULATOR BEFORE TURNING ON ELECTRICITY.

PROGRAMMING INSTRUCTIONS

•TO SET “ON” AND “OFF” TIMES: Hold trippers

against edge of CLOCK-DIAL, pointing to time (AM or

PM) when ON and OFF operations are desired,

tighten tripper screws firmly. For additional tripper pairs

on CLOCK-DIAL order 156T1978A.

•TO SET TIME-OF-DAY: Pull CLOCK-DIAL outward.

Turn in either direction and align the exact time-of-day

on the CLOCK-DIAL (time now, when switch is put into

operation) to TIME POINTER. DO NOT MOVE

POINTER.

OPERATING INSTRUCTIONS

•TO OPERATE SWITCH MANUALLY: Move MANUAL

LEVER below CLOCK-DIAL left or right as indicated by

arrows. This will not effect next operation.

•INCASEOFPOWERFAILURE, reset CLOCK-DIAL to

proper time-of-day. See programming instructions.

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

158TS10915

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO

ORDER REPLACEMENT, INDICATE PART NO. (WG--) ON MOTOR COVER.

CLOCK

MOTOR

WIRING

DIAGRAM

120V

SUPPLY

LOADS

GROUND

LINE

NEUT.

CLOCK

DIAL

TIME

POINTER

OFF

TRIPPER

MANUAL

LEVER

TRIPPER

MINIMUM

COPPER

WIRE SIZE

(AWG)

MAX.

LOAD

(AMP)

MIN.

INSUL-

ATION

TEMP (°C)

75° INSULATION MAX. MOTOR

LOAD (HP)

SINGLE PHASE

120V 240V

1/2

2 1/2

PRESSURE PLATE

TERMINAL SCREW

MAKE SURE WIRE

INSULATION CLEARS

PRESSURE PLATE

3 PHASE

240V 240V

N/A

GR.

FIGURE 1

LR3730

MODEL: T101R3 1

Inhaltsverzeichnis

Seite 1 - MODEL: T101R3

MODEL: T101R324 HR. DIAL TIME SWITCH (SPST)IN TYPE 3R DUSTPROOF RAINPROOF ENCLOSURE, SUITABLE FOR POOLEQUIPMENT CONTROL IF INSTALLED 5 FT. OR MORE FR

Kommentare zu diesen Handbüchern

Keine Kommentare

Intermatic T101R3 Bedienerhandbuch

Stöbern Sie online oder laden Sie Bedienerhandbuch nach Oberirdisches Schwimmbadzubehör Intermatic T101R3 herunter. Intermatic T101R3 Instructions / Assembly Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern